Please Note: You are viewing the unstyled version of Stalcop. Either your browser does not support CSS (Cascading Style Sheets) or it is disabled. As a result, much of this website will not look the way it was intended, although all of its contents will be accessible to you. For more information, visit our Browser Support page.

Skip to Search This Site, Primary Site Navigation, Secondary Site Navigation, Content, Company Address

Upsetting.

Upsetting

Material contained in the die is forced outward by the punch to produce a large cross section than the initial blank. Diameter increases of 2-3 times the starting diameter are possible with this technique.

Combinations of these basic techniques are used to produce complicated multi-featured parts, often in one cycle.

Upsetting Process Top of Page